THE PRODUCTS ON THIS WEBSITE ARE INTENDED FOR ADULTS ONLY.
By entering this website, you certify that you are of legal smoking age in the state in which you reside
This VT software is for upgrading your CUBOID Lite to the latest Firmware Version. Your temperature control device will be always up to date because of upgradeable firmware.
What’s special in Version 1.01? Preheat Function
The Cuboid Lite comes with the preheat function, allowing to start firing at a high output for a few seconds to warm up. This is especially an essential when using an RDA, RTA, ceramic heads and so on.
Long press the fire button and ‘+’ button simultaneously to activate the menu. Click ‘+’ again to enter into the preheat setting. Click ‘-’ button to adjust the preheat wattage. Click the fire button to switch to the duration. Click ‘-’ button to turn on the ‘Preheat’ function and set the duration. The device will run at this wattage for the time you set everytime you hold the fire button (under power mode). There’ll also a small ‘P’ on the info bar after you activate it.
Long press the fire button and ‘+’ button simultaneously to activate the menu. Click ‘+’ 2 times to enter into the nicotine intake setting. Click ‘-’ button to turn it on. Click the fire button to switch to set the nicotine strength (from 1- 100 mg/ml). Click the fire button to confirm. Then you’ll notice a small emoji with smile on the upper left. And when the nicotine intake amounts to a higer degree the emoji changes to be sad.
For safety reasons, if you hold the fire button over a certain period, the device will shout down automatically. Press the fire button 5 times to turn it on again.
Long press the fire button and ‘+’ button simultaneously to activate the menu. Click ‘+’ 3 times to enter into the timeout setting. Click ‘-’ button to set the duration from 5s to 15s. Click the fire button to confirm.
Temperature protect for charging
We applied the exclusive temperature protect technology (ENU) into the CUBOID Lite mod. It'll stop charging automatically when temperature is beyond the applicable scope to protect the battery.
Long press the fire button and '+' button simultaneously and then press '+' button 4 times to enter into ENU menu. Click '-' button to turn it on or off.
n order to protect the atomizer head systematically, we specially designed the power limit for certain ohm range. Moreover, when you happen to install a high ohm coil head under high power condition, output wattage will drop down to the safe power limit automatically to avoid dry burn.
Long press the fire button and “＋” button simultaneously to enter into the menu system. Click “＋” button 5 times to enter into the power limit setting. Press the fire button to switch between different ohm range according to your atomizer head resistance. Click “－” button to adjust the limit output.