After upgrading this program, all data will turn to the default Settings. So please upload vapor data into MVR software before upgrading eVic, avoiding data loss.
Sometimes, maybe the factory default settings of your eVic will be reset during upgrading,synchronization time or setting modification.
At this time, you need reset through upgrading factory default program.
The procedure: Connect eVic to your computer, then click "Get Data From ecig" to upload eVic's data and back up it in yourcomputer.
1. Real VW adjustment
We change the option 'Power set' name to 'Vapor set'. And then add option 'VV', 'VW' into sub-option 'Switch' of 'Power set'. When you choose 'VV' or 'VW', you are able to adjust voltage or wattage directly in the main interface.
2. Atomizer real time detection
Real time automatically resistance detecting, to guarantee you have a real Watt output and a real display information whenever you change one atomizer.
3. Wattage arrange modification
Due to hardware and software limitations, eVic cannot reach 15W. So we modified the range to 2-11W. And the range will change depend on the resistance. e.g. , when you use 2.1Ω, the range will be 4.2W-11W.
4. Fast voltage/wattage adjustment
In the main interface, turn the direction key in one direction three times fast, then voltage or wattage will be increased or decreased fast automatically. Turn the direction key in opposite direction to stop.
5. Warning temperature adjustment
We add sub-option 'Current ℃' and 'Alarm ℃' into option 'Temp ℃'. In 'Alarm ℃', you can adjust the warning temperature and decide when the overheating mark flashes.
Check "eVic V1.1 introduction and download guidance"