eGrip II Light Body
eGrip II Light
eGrip II Light, a new version of eGrip II, crafted from super light magnesium alloy has a deep, high-gloss finish of multiple colors. The eGrip II Light adopts the best anti-leaking structure with top refilling and top airflow control system. Large 0.96 inch OLED screen, clock screensaver and multiple tank lights all make it more practical and attractive catering to your preference. Meanwhile, upgradeable firmware always enables it up-to-date.
Standard Configuration:

1*eGrip II Light Body
1*USB Port
1*Atomizer Adapter(for eGrip II Light)
1*Manual & Warranty Card
1*Warning Card


eGrip II Light
Specification:
Size: 24.00*45.00*100.55mm
Output Mode: RTC/VW/VT(Ti, Ni, SS316)/Bypass/TCR(M1, M2, M3)
Output Wattage: 1-80W
Battery Capacity: 2100mAh
Resistance Range: 0.05-1.5ohm for VT mode
Resistance Range: 0.1-3.5ohm for VW/BYPASS mode
Temperature Range: 100-315°C/ 200-600°F
Colors: Blue Wrinkle, Black Wrinkle, Orange Wrinkle, Red Wrinkle
eGrip II Light
Magnesium alloy, super light
Crafted from magnesium alloy, our new eGrip II Light has a deep, high-gloss finish of multiple colors.
eGrip II Light
RTC (Real Time Clock) on display
eGrip II Light applies the RTC (Real Time Clock) function.
It enables you to switch between digi clock and analog clock. Also, you can set it as screensaver.
eGrip II Light
Dual Circuit Protection
eGrip II Light applies two sets of battery protection circuit system, realizing overall battery protection of
over-charging, over-current and over-discharging, which makes it more safe and reliable.
eGrip II Light
Fashionable Tank Lights
Multiple colors of tank lights make eGrip II Light more attractive and fashionable catering to your preference.
eGrip II Light
Apply the Atomizer Adapter
Unscrew the airflow ring and remove the whole part. Screw the atomizer adapter tightly with a coin,
then you're able to apply multiple types of atomizers with the 510 pin.
eGrip II Light
Firmware Upgradeable
eGrip II Light comes with the upgradeable firmware.
The latest firmware version 5.04 for eGrip II Light with new interface and preheat function are now available.
eGrip II Light
eGrip II Light
How to Reset The Device
eGrip II Light
Charging & Upgrading
The micro USB port is on the top of the left side. Connect it with a micro USB cable to charge or upgrade your device. Simply charge eGrip II Light by connecting it with the wall adapter or a computer via USB cable. The battery is charged as shown in the picture. When it is fully charged, the charging bar will disappear.
eGrip II Light

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our private policy>

Web Statistics