VT Software to Upgrade EKEE

This VT software is for upgrading your EKEE to the latest Firmware Version. Your temperature control device will be always up to date because of upgradeable firmware.

What’s special in Version 1.00?
Preheat Function
The EKEE comes with the preheat function, allowing to start firing at a high output for a few seconds to warm up. This is especially an essential when using an RDA, RTA, ceramic heads and so on.

Nicotine intake
Long press the fire button and ‘+’ button simultaneously to activate the menu. Click ‘+’ again to enter into the preheat setting. Click ‘-’ button to adjust the preheat wattage. Click the fire button to switch to the duration. Click ‘-’ button to turn on the ‘Preheat’ function and set the duration. The device will run at this wattage for the time you set everytime you hold the fire button (under power mode). There’ll also a small ‘P’ on the info bar after you activate it.
Long press the fire button and ‘+’ button simultaneously to activate the menu. Click ‘+’ 2 times to enter into the nicotine intake setting. Click ‘-’ button to turn it on. Click the fire button to switch to set the nicotine strength (from 1- 100 mg/ml). Click the fire button to confirm. Then you’ll notice a small emoji with smile on the upper left. And when the nicotine intake amounts to a higer degree the emoji changes to be sad.

Timeout protection
For safety reasons, if you hold the fire button over a certain period, the device will shout down automatically. Press the fire button 5 times to turn it on again.
Long press the fire button and ‘+’ button simultaneously to activate the menu. Click ‘+’ 3 times to enter into the timeout setting. Click ‘-’ button to set the duration from 5s to 15s. Click the fire button to confirm.

Temperature protect for charging
We applied the exclusive temperature protect technology (ENU) into the EKEE mod. It’ll stop charging automatically when temperature is beyond the applicable scope to protect the battery.
Long press the fire button and ‘+’ button simultaneously and then press ‘+’ button 4 times to enter into ENU menu. Click ‘-‘ button to turn it on or off.